PRODUCT SPECIFICATIONS
 
Use with 7-8mm gel balls (gel balls are made of water polymer, easy to break and non toxic)
 
***Take Note: Gel balls included with Blasters are generally of low quality and can often cause feeding issues hence we highly recommend purchasing our high quality Hardened Gel Balls for the best performance***
 
PERFORMANCE
Approx 15-25M shooting distance
Up to 260 FPS
 
UPDATED VERSION/Metal gear/Metal cylinder/Metal nozzle/Metal rubber stud/Upgrade spring/Upgrade motor/Metal tube/HOP UP/11.1 battery + charger/Milky white gel ball
 
MOSFET UPGRADE VERSION
 
On The Basis Of The Upgraded Version, Add A Mosfet. And Install Shs Metal Gear And Ndfeb Motor
1 Add The Function Of Feeding In Advance
2add Binary Trigger Mode
3 Better Battery Protection
3 Increase The Function Of Three Bursts And Five Bursts
4 Make The Output Of The Gel Ball More Stable
 
INTRODUCTION MOSFET
Mode Control
A. Single Shot Mode
B. Dual Stroke Mode
C. Triple Burst Mode
D. Piston Back Chamber Amplitude Control (Eight Gears)
 
The Switching Method Of Abc Three Modes:
In The Single Engine Mode Of The Fast And Slow Engines, Quickly Switch To The Continuous Mode, And Then Switch To The Single Engine Mode, And The Transmission Mode Will Be Changed. After Each Switch, A Corresponding Prompt Sound Will Appear. (Single Engine Means One Motor Beep, Double Stroke Means Two Beeps, And Three Consecutive Engine Means Three Beeps)
 
Adjustment Method For D: (It Needs To Be Adjusted In The Three Emission Modes Of Abc)
There Are A Total Of Eight Gears In The Piston Travel. After Pressing And Holding The Trigger For 2 Seconds And Hearing The Corresponding Motor Sound, It Defaults To Adding One Gear (One Beep For One Gear, Two Beeps For Two Gears, And So On). If You Increase It Again At Level Eight, You Will Return To Level One. The Adjustment Of The Ladder Travel Only Needs To Be Done When The Return Plate Cannot Fully Return.
 
CAUTION
-Recommended for ages 14 and above
-Charge the battery for at least 4 hours
-Soak your gel balls for 4 hours or more for maximum hydration
-Don’t fire at people or animals
-Please wear safety protective google when using
-After shooting, remove the battery to save power and leak the battery.
-Please do not modify it as we do not cover configuration of the default set.
** Colors may look differently on individual monitor due to the color setting and lighting etc.**
 
SOAKING GEL BALL PROCESS
 
REQUIREMENT
1. Pack of Gel Balls
2. Bucket
3. Water
 
GEL BALL / WATER RATIO
10,000 / 4L Water
5,000 / 2L Water
500 / 300ml Water
 
METHOD
Step 1: Empty the gel ball pack into bucket
Step 2: Fill bucket with water (the more the better)
Step 3: Allow gel ball to soak for 4 hours minimum! (overnight recommended!!)
Your gel balls are now ready to use.
 
Storage: Up to 2 weeks in an airtight container away from sunlight. For best results , store in water and strain when needed.